Free circuit diagrams

Bookmark and Share
privacy policy

Touch Switch II

A touch switch is a switch that is turned on and off by touching a wire contact, instead of flicking a lever like a regular switch. Touch switches have no mechanical parts to wear out, so they last a lot longer than regular switches. Touch switches can be used in places where regular switches would not last, such as wet or very dusty areas.

Circuit diagram

C1 10uF 16V Electrolytic Capacitor
R1, R2 100K 1/4 Watt Resistor
R3 10 Meg 1/4 Watt Resistor
U1 4011 CMOS NAND Gate IC
MISC Board, Wire, Socket For U1

1. The contacts an be made with just two loops of wire close together, or two squares etched close together on a PC board.
2. When activated, the output of the circuit goes high for about one second. This pulse can be used to drive a relay, transistor, other logic, etc.
3. You can vary the length of the output pulse by using a smaller or larger capacitor for C1.


Link to this page for forums and blogs:
All content on this site is provided as is and without any guarantee on any kind, implied or otherwise. We cannot be held responsible for any errors, omissions, or damages arising out of use of information available on this web site. The content in this site may contain COPYRIGHTED information and should not be reproduced in any way without prior permission from the authors. Be aware! Electricity can kill! © 2008.
page generated in :0.0239